Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.19 PISTON, PISTON RING, AND CONNECTING ROD 2. Install the wrist pin in the piston. See Figure 1-110. 1. Piston 2. Wrist Pin 3. Connecting Rod Figure 1-110 Wrist Pin [a] Lubricate the wrist pin with a light coating of clean engine oil. [b] Insert the wrist pin into the wrist pin bore. [c] Secure the wrist pin with the two snap rings. Orient the rings at a 12 o'clock and 6 o'clock position. 3. Install the piston rings on the piston (1). See Figure 1-111. Refer to section 1.19.3. Figure 1-111 Ring Gaps Offset 120 Degrees [a] Lubricate the piston with a light coating of clean engine oil. [b] Install each piston ring in the appropriate groove on the piston.

All information subject to change without notice. 1-126 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION