EPA07 MBE 4000 SERVICE MANUAL 4. Offset the ring gaps alternately by 120 degrees. NOTICE: The half of the bearing shell installed in the connecting rod (rod half) has a specially-treated friction surface that allows it to bear higher loads. It cannot be interchanged (swapped) with the other half of the bearing shell installed in the bearing cap (cap half). 5. Install the rod half of the bearing shell in the connecting rod, as marked on removal. See Figure 1-112. 1. Connecting Rod 3. Bearing Cap 2. Bearing Shells Figure 1-112 Bearing Shells [a] Be sure that the locking lug in the bearing shell is fully seated in the groove of the rod.
[b] Lubricate the bearing surface with a light coating of clean engine oil. 6. Lubricate the cylinder liners with a light coating of clean engine oil. NOTICE: Be careful not to scratch the crankshaft journals with the connecting rod. This can lead to premature wear of the crankshaft. 7. Clamp ring compressor (J–45983) to compress the piston rings. 8. If reusing a cylinder liner, thoroughly clean the carbon scraper ring seat. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-127