Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.19 PISTON, PISTON RING, AND CONNECTING ROD 20. Using a dial gauge and holder, measure the piston protrusion relative to crankcase top dead center at all the pistons. See Figure 1-115. 1. Piston 2. Cylinder Liner A. Protrusion = 0.244 to 0.715 mm (0.0096 to 0.0281 in.) Figure 1-115 Piston Protrusion at Top Dead Center 21. If piston protrusion is between 0.244 mm (0.0096 in.) minimum and 0.715 mm (0.0281 in.) maximum then continue to next step. If not within specification, check piston, piston pin, piston pin bushings, connecting rod and crankshaft. Refer to piston protrusion specifications, listed in Table 1-33. [a] Inspect piston, piston pin bushings and piston pin for wear or damage.

If damaged, repair as necessary. [b] Inspect connecting rod for bent rod, pin bushing wear or damage. If damaged, repair as necessary. [c] Inspect rod bearings for wear or damage. If damaged, repair as necessary. [d] Inspect crankshaft for damage to rod journal or for evidence of spun bearing. If damaged, repair as necessary. Table 1-33 Piston Protrusion Specifications 22. Remove the engine barring tool (J–46392). Refer to section “Engine Barring Tool Removal.” All information subject to change without notice. 1-130 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description Specification: mm (in.) Piston Protrusion (at TDC) 0.244 – 0.715 (0.0096 – 0.0281)