1.20 VALVES 1.20.3 Removal of Valve Removal steps are as follows: NOTE: The MBE 4000 engine has individual heads for each cylinder. To replace the valves on one head, follow these instructions, step by step. To replace all the valves, repeat these instructions for all six cylinder heads. 1. Remove the cylinder head from the engine. Refer to section 1.3.1. 2. Using a dial gauge and holder, measure the valve head recess depth from the cylinder head. Refer to section 1.20.2. Listed in Table 1-38 are the normal tolerances and wear limits. Table 1-38 Valve Head Recess Depth 3. Place the cylinder head on cylinder head fixture,(J–46175). 4.
Attach the valve spring remover tool, (J–46173), to the cylinder head. See Figure1-128. 1. Valve 2. Cylinder Head Figure 1-128 Valve All information subject to change without notice. 1-144 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Valve Type Description Recess Depth mm (in.) Intake Normal 0.7-1.1 (0.03-0.04) Intake Wear Limit 1.6 (0.06) Exhaust Normal 0.7-1.1 (0.03-0.04) Exhaust Wear Limit 1.6 (0.06)