Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 3. Measure the valve head recess depth listed in Table 1-37, from the cylinder head. See Figure 1-127. NOTE: The valve head recess depth is the difference in height between the lower contact surface of the cylinder head and the valve head, when it is touching the valve seat. 1. Cylinder Head 3. Valve Stem 2. Valve Head Figure 1-127 Measuring Valve Head Recess Depth Table 1-37 Valve Head Recess Depth [a] Set the scale of the dial gauge to "0" (zero). [b] Move the dial gauge enough so that its probe is touching the valve head.

[c] If the gauge reads between 0.7 and 1.1 mm (0.03 and 0.04 inch), the valve head recess depth is within specifications for new cylinder heads. [d] If the gauge reads less than 0.7 mm (0.03 inch), or more than 1.1 mm (0.04 inch), the valve head recess depth is not within specifications, Refer to section 1.20.3. [e] For used heads, if the gauge reads more than 1.6 mm (0.06 in.), inspect valves and valve seats. Listed in Table 1-40 are the specifications. 4. Install the cylinder head. Refer to section 1.3.2. All information subject to change without notice.

DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-143 Valve Type Description Recess Depth mm (in.) Intake Normal 0.7-1.1 (0.03-0.04) Intake Wear Limit 1.6 (0.06) Exhaust Normal 0.7-1.1 (0.03-0.04) Exhaust Wear Limit 1.6 (0.06)