EPA07 MBE 4000 SERVICE MANUAL 9. Inspect the valve guides for wear. See Figure 1-131. Listed in Table 1-39 are the specifications. 1. Valve Guide 2. Cylinder Head Figure 1-131 Measuring the Inside Diameter of the Valve Guide Table 1-39 Inside Diameter of Valve Guide [a] Measure the inside diameter of the valve guide by inserting the go/no go gauge (J–46181) into the valve guide. [b] Replace the valve guide if the larger diameter end of the go/no go gauge tool (J–46181) fits into either end of the guide. 10. Clean the valves thoroughly. Remove any traces of combustion residue. 11. Check the valves to see if they can be re-used.
Replace the valves if the stem ends are damaged or bent, if the valve grooves are deformed, if the seat is burned, or if the chrome surface of the shaft is not entirely intact. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-147 Description Value: mm (in.) Normal 9.000-9.022 (0.3543-0.3552) Wear Limit 9.050 (0.3563)