Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.20 VALVES 12. Check the following critical valve dimensions, and repair as necessary. See Figure 1-132 to determine the dimensions given in the table. Listed in Table 1-40 are the dimensions. Valve stem diameter (A) Valve seat diameter at the contact surface of the cylinder head (B) Valve head diameter (C) Valve seat height (D) Valve seat width at the valve head (E) Valve seat angle (F) Valve length (G) Figure 1-132 Critical Dimensions, Valve Stem and Head Table 1-40 Valve Specifications 13. Check the condition of the valve seat insert. Repair the insert if necessary.Refer to section 1.20.6. All information subject to change without notice.

1-148 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description Intake mm (in.) Exhaust mm (in.) Valve Stem Diameter (A) 8.935-8.950 (0.3518-0.3524) 8.925-8.940 (0.3514-0.3520) Valve Seat Diameter, at Head Contact Surface (B) 42.0 (1.65) 39.0 (1.54) Valve Head Diameter (C) 45.4-45.6 (1.79-1.80) 41.9-42.3 (1.65-1.67) Valve Seat Height-New (D) 3.1-3.3 (0.12-0.13) 3.0-3.3 (0.12-0.13) Minimum Valve Seat Height-After Grinding (D) 2.9 (0.11) 2.9 (0.11) Valve Seat Width, at Valve Head (E) 3.5-4.5 (0.14-0.18) min. 3.5 (0.14) Valve Seat Angle (F) 30 degrees 36 degrees Valve Length (G) 145.0 (5.71) 145.0 (5.71)