EPA07 MBE 4000 SERVICE MANUAL 14. Inspect the valve springs. Check the springs for correct pressure, using the values listed in Table 1-41. If damaged, replace the springs. Table 1-41 Spring Specifications, Intake and Exhaust Valves 1.20.4 Installation of Valve Installation steps are as follows: 1. Install the valve stem sealing ring in the valve guide in the cylinder head. 2. Lubricate each valve with a light coating of engine oil. 3. Install the valves in order, as marked on removal. NOTE: Always replace the valve stem seal and valve stem sealing ring if the valve has been removed. Check the valve stem seal to make sure it is correctly seated on the valve guide. 4.
Using valve stem seal protector (J–46174), install new valve stem seals and seat the valve stem seal with installer tool, (J-46184). Refer to section 1.20.5. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-149 Description mm (in.) Length, Without Load 69.7 (2.74) Length, Under Load of 382-418 N (86-94 lbf) 49 (1.9) Length, Under Load of 644-706 N (145-159 lbf) 37 (1.5) Diameter of Spring Wire 4.2 (0.17) Outside Diameter of Spring Coil 28.9 (1.14) Inside Diameter of Spring Coil 24.5-24.9 (0.96-0.98)