Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.21 ROCKER ARM 1.21 ROCKER ARM Perform the following procedures for removal and installation of the rocker arm: 1.21.1 Removal of Rocker Arm Assembly Removal steps are as follows: 1. Remove the injector harness adaptor frame. Refer to section 2.5.1. 2. Remove the rocker arm assembly. See Figure 1-137. 1. Cylinder Head Cover 4. Intake Valve Bridge 2. Rocker Arm Mounting Bolt 5. Exhaust Valve Bridge 3. Rocker Arm Assembly 6. Pushrods Figure 1-137 Rocker Arm Assembly [a] Loosen the each valve lash adjusting screw. [b] Remove each rocker arm mounting bolt. [c] If removing more than one rocker arm assembly, mark the assembly with a paint pen to identify it on installation.

[d] Remove the rocker arm assembly from the cylinder head. 3. Inspect the rocker arm assembly for wear. If necessary, disassemble the rocker arm assembly and replace any worn parts. Refer to section 1.21.2. All information subject to change without notice. 1-154 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION