Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 4. Measure each rocker arm mounting bolt. Replace each bolt longer than 91 mm (3.6 inches), as listed in Table 1-43. Table 1-43 Rocker Arm Mounting Bolts Specifications 5. Remove the valve bridge from each set of valves, intake and exhaust. 6. Inspect the valve bridges for wear. If necessary, replace any worn valve bridge(s). 1.21.2 Disassembly of Rocker Arm Disassembly steps are as follows: 1. Remove the rocker arm assembly from the cylinder head. Refer to section 1.21.1. 2. Remove the snap rings from each end of the rocker arm shaft. See Figure 1-138. 1. Snap Ring 5. Intake Rocker Arm 2. Washer 6. Locknut 3. Exhaust Rocker Arm 7. Adjusting Screw 4.

Rocker Support Figure 1-138 Rocker Arm Components 3. Remove the rocker arms and washers from the shafts on each end of the rocker arm support. Keep all parts in order, as removed, for ease of assembly. [a] Remove the intake rocker arm and washer. [b] Remove the exhaust rocker arm and washer. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-155 Size Max. Shaft Length mm (in.) Torque Nm (lb ft) M10 91 (3.6) 60 (44) M10 91 (3.6) additional 90°