1.21 ROCKER ARM [c] Remove the adjusting screw and locknut from both intake and exhaust rocker arms. [d] Mark each rocker arm and shaft with paint pens, for ease of installation. 4. Inspect the parts of the rocker arm assembly for wear, and replace if necessary. 1.21.3 Assembly of Rocker Arm Assembly steps are as follows: 1. Install the adjusting screw and locknut on both intake and exhaust rocker arms. Tighten the locknut 50 N·m (37 lb·ft). 2. Inspect the inside diameter of the rocker arm bushing. Replace the rocker arm bushing if the inside diameter is smaller than 25.005 mm (0.9844 in.) or larger than 25.021 mm (0.9851 in.) as listed in Table 1-44.
Table 1-44 Rocker Arm Bushing Specifications 3. Inspect the diameter of the rocker arm shaft. Replace the rocker arm shaft if the diameter is smaller than 24.967 mm (0.9830 in.) or larger than 24.980 mm (0.9835 in.). 4. Lubricate the washers, rocker arm bushings, and the shafts of the support with a light coating of engine oil. 5. Install the rocker arms and washers on the correct rocker arm shaft, as marked on removal. Make sure both intake and exhaust rocker arms are installed correctly. 6. When the assembly is complete, secure the assembly by installing a snap ring on the end of each rocker arm shaft. 1.21.4 Installation of Rocker Arm Installation steps are as follows: 1.
Install a valve bridge on each set of valves, both intake and exhaust. 2. Lubricate each pushrod with a light coating of engine oil. All information subject to change without notice. 1-156 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description Specification, mm (in.) Bushing Inside Diameter (when installed) 25.005-25.021 (0.9844-0.9851) Shaft Diameter 24.967-24.980 (0.9830-0.9835)