EPA07 MBE 4000 SERVICE MANUAL 3. Inspect each pushrod to be sure it is correctly seated in its tappet. Replace any pushrods that are warped, are not correctly seated, or are not the correct length as listed in Table 1-45. Table 1-45 Rocker Arm Specifications 4. Install the rocker arm assembly. [a] Position the rocker arm assembly on the cylinder head, as removed. [b] Install the mounting bolts in the holes in the cylinder head. [c] Tighten each mounting bolt 60 N·m (44 lb·ft). Final angular tightening: 90 degrees. 5. Adjust the valve lash. Refer to section 13.1. 6. Install the injector harness adaptor frame. Refer to section 2.5.2. All information subject to change without notice.
DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-157 Description Specification mm (in.) Total Length of Pushrods 345.0-346.5 (13.58-13.64) Maximum Pushrod Warpage 0.5 (0.02) Maximum Length of Rocker Arm Mounting Bolts 91 (3.6)