1.22 CAMSHAFT AND GEAR ASSEMBLY 1. Disconnect the electrical connector. See Figure 1-146. 1. Camshaft Position Sensor 2. Crankshaft Position Sensor Figure 1-146 Camshaft Position Sensor 2. Remove the CMP sensor from the access hole in the flywheel housing. 3. Install a new CMP sensor in the flywheel housing. Push sensor downward until it contacts the flywheel housing. 4. Connect the electrical connector to the CMP. NOTE: Be sure that the correct electrical connector is connected to the sensor. All information subject to change without notice. 1-168 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION