Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 14. Lubricate the pushrods with a light coating of clean engine oil. Install the pushrods and the rocker arm assemblies. Refer to section 1.21.4. FALLING ENGINE To avoid injury from a falling engine, an adequate lifting device with a spreader bar and sling should be used to lift the engine. The sling and spreader bar should be adjusted so the lifting hooks are vertical to prevent bending the lifter brackets. To ensure proper weight distribution, all provided lifter brackets must be used. NOTICE: A spreader bar must be used at all times in conjunction with the front and rear lifter brackets to lift the EGR engine to ensure that no engine damage will result.

The brackets are designed to lift vertically. 15. Remove the engine from the stand and install it in the vehicle. 16. Fill the engine with oil. 17. Fill the engine with coolant. Refer to section 4.1.1. 1.22.3 Replacement of Camshaft Position Sensor Replacement steps are as follows: All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-167