Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.22 CAMSHAFT AND GEAR ASSEMBLY [f] Remove the guide sleeve and pilot disc from the camshaft. 1. Drive Gear Mounting Bolt 4. Fuel Pump Drive Gear 2. Front Camshaft Cover 5. Front of Camshaft 3. Cover Mounting Bolt 6. Fuel Pump Driven Gear Figure 1-145 Camshaft Assembly 4. Secure the fuel pump drive gear to the front of the camshaft with four new bolts. Torque the bolts to 60 N·m (44 lb·ft.). See Figure 1-145. 5. Check the backlash between the camshaft gear and the crankshaft gear, see specification listed in Table 1-47. 6. Install the flywheel housing. Refer to section 1.18.2. 7. Install the oil pan. Refer to section 3.2.2 8. Turn the engine on the stand until it is top side up. 9.

Install the unit pumps. Refer to section 2.1.3. 10. Install the camshaft front cover on the cylinder block, as removed. Torque the mounting bolts to 50 N·m (37 lb·ft.). See Figure 1-140. 11. Install the air conditioning compressor, alternator, and mounting bracket. Refer to section 9.2.2. 12. Install the fan support. Refer to section 4.3.2. 13. Install the vibration damper. Refer to section 1.13.2. All information subject to change without notice. 1-166 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION