EPA07 MBE 4000 SERVICE MANUAL Flywheel and Flywheel Housing The flywheel specifications are listed in Table 1-69. The ring gear specifications are listed in Table 1-70. Listed in Table 1-71 are the torque values for the flywheel and the flywheel housing. The tightening stages for the flywheel mounting bolts are listed in Table 1-72. Table 1-69 Flywheel Specifications Table 1-70 Flywheel Ring Gear Specifications Table 1-71 Torque Values for Flywheel and Flywheel Housing Table 1-72 Tightening Stages, Flywheel Mounting Bolts All information subject to change without notice.
DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-175 Description Specification mm (in.) Flywheel Outside Diameter 486.60-487.40 (19.157-19.189) Flywheel Shoulder Diameter (for ring gear mounting) 432.450-432.645 (17.0256-17.0333) Flywheel Diameter at Crankshaft Flange 114.980-115.015 (4.5268-4.5282) Flywheel Diameter for Mounting Clutch 475.000-475.063 (18.7008-18.7033) Flywheel Minimum Width Between Friction Surface and Mounting Flange After Machining 60 (2.4) Flywheel Maximum Overall Width 70 (2.8) Peak-to-Valley Height (R z) of Clutch Friction Surface 0.016 (0.006) Flywheel Permissible Deviation From True (radial and lateral) 0.2 (0.008) Description Specification, mm (in.) Flywheel Shoulder Diameter (for ring gear mounting) 432.450-432.645 (17.0256-17.0333) Hole for Mounting Clutch Pressure Plate M10 x 1.5 Ring Gear Inside Diameter 432.000-432.155 (17.0078-17.0140) Ring Gear/Flywheel Interference Fit 0.295-0.645 (0.0116-0.0254) Ring Gear/Flywheel Permissible Radial Runout 0.5 (0.02) Ring Gear Width 18.4-18.6 (0.72-0.73) Ring Gear Fitting Temperature 200-230°C (390-450°F) Item Torque, N·m (lb·ft) Inspection Cover on Flywheel Housing 25 (18) Flywheel Housing Mounting Bolts (to cylinder block) 70 (52) Vibration Damper Mounting Bolts (to crankshaft) 200 (148) Max.
Shaft Length, mm (in.) Tightening Stage Torque N·m (lb·ft) 77.0 (3.03) Stage 1 200 (148) 77.0 (3.03) Stage 2 90 degrees