Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

Table 1-81 Bushing Specifications Valves The valve removal/installation specifications are listed in Table 1-82. The valve head recess depth specifications are listed in Table 1-83. The valve guide inside diameter measurements are listed in Table 1-84. The spring specifications for the intake and exhaust valves are listed in Table 1-85. The valve lift specifications are listed in Table 1-86. The measurements for valve lash checking are listed in Table 1-87. The measurements for valve seat specifications for an EGR engine are listed in Table 1-88. Table 1-82 Valve Removal/Installation Specifications Table 1-83 Valve Head Recess Depth All information subject to change without notice.

1-178 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description Dimensions:

mm (in.) Inside Diameter of Bushing 52.05-52.07 (2.049-2.050) Outside Diameter of Bushing 57.080-57.100 (2.2472-2.2480) Inside Diameter of Bushing Bore 57.000-57.019 (2.2441-2.2448) Bushing Interference Fit 0.061-0.100 (0.0024-0.0039) Maximum Permissible Out-of-Round in Bushing Bore 0.01 (0.0004) Description Intake, mm (in.) Exhaust, mm (in.) Valve stem diameter (A) 8.935-8.950 (0.3518-0.3524) 8.925-8.940 (0.3514-0.3520) Valve seat diameter at head contact surface (B) 42.0 (1.65) 39.0 (1.54) Valve head diameter (C) 45.4-45.6 (1.79-1.80) 41.9-42.3 (1.65-1.67) Valve seat height-new (D) 3.1-3.3 (0.12-0.13) 3.0-3.3 (0.12-0.13) Minimum valve seat height-after grinding (D) 2.9 (0.11) 2.9 (0.11) Valve seat width at valve head (E) 3.5-4.5 (0.14-0.18) min.

3.5 (0.14) Valve seat angle (F) 30 degrees 36 degrees Valve length (G) 145.0 (5.71) 145.0 (5.71) Valve Type Description mm (in.) Intake Normal 0.7-1.1 (0.03-0.04) Intake Wear Limit 1.6 (0.06) Exhaust Normal 0.7-1.1 (0.03-0.04) Exhaust Wear Limit 1.6 (0.06)