Sensor and Fittings The torque specifications for the fuel and coolant temperature sensors as well as some fittings are listed in Table 1-95. Table 1-95 Sensor and Fittings Torque Values Special Tools The special tools used within this chapter are listed in Table 1-96. All information subject to change without notice.
1-182 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description Torque N·m (lb·ft) Deaeration Line Banjo Bolt 35 (26) Constant Throttle Valve (CTV) Air Supply Line Banjo Bolt 45 (33) Fuel Temperature Sensor to Engine Block 30 (22) Coolant Temperature Sensor to the Engine Block 30 (22) Trim Cover Bolts 12 (9) Tool Description Usage Part Number Slide Hammer Used to remove the flywheel pilot bearing. J-6471–02 Impact Socket Use to remove and install the cylinder head bolts. J–45389 19-mm Flywheel and Main Pulley Socket Use to remove and install the flywheel and main front pulley. J–45390 Front Seal Installer Used to install the front crankshaft radial seal.
J–45391 (part of kit J-47273) Rear Crankshaft Seal Installer Used to install the rear crankshaft radial seal. J–45393–A (part of kit J-47273) Cylinder Liner Removal Tool Used when removing the cylinder liner. J–45876