Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL Camshaft and Camshaft Sensor The camshaft specifications arelisted in Table 1-92. The valve tappet specifications are listed in Table 1-93. Listed in Table 1-94 are the torque values for the camshaft. Table 1-92 Camshaft Specifications Table 1-93 Valve Tappet Specifications Table 1-94 Camshaft Torque Values All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-181 What To Measure Where To Measure Value:

mm (in.) Unless otherwise noted Hardness of Surface At Cams and Journals 57–63 HRC Camshaft Radial Runout When Mounted on Outer Bearing Journals At Gear Seat 0.020 (0.0008) Camshaft Radial Runout When Mounted on Outer Bearing Journals At Cam Circle 0.025 (0.0010) Camshaft Radial Runout When Mounted on Outer Bearing Journals At Camshaft Journals 0.030 (0.0012) Minimum Valve Cam Rise–Above Basic Circle Intake Valve 7.3 (0.29) Minimum Valve Cam Rise–Above Basic Circle Exhaust Valve 8.2 (0.32) Camshaft Journal Diameter For New Camshaft 81.893–81.928 (3.2241–3.2255) Bushing Diameter At Camshaft Journals 82.000–82.035 (3.2283–3.2297) Gear Back Lash Cam Gear to Crank Gear 0.074–0.176 (0.0029–0.0069) Gear Back Lash Cam Gear to Air Compressor Gear 0.082–0.168 (0.0032–0.0066) Description Repair Stage Specifications, mm (in.) Tappet Outside Diameter Standard 29.931-29.952 (1.1784-1.1792) Tappet Outside Diameter Repair Stage I 30.444-30.465 (1.1986-1.1994) Tappet Housing Diameter (in cylinder block) Standard 30.000-30.021 (1.1811-1.1819) Tappet Housing Diameter (in cylinder block) Repair Stage I 30.500-30.525 (1.2008-1.2018) Fastener Type N·m (lb·ft) Camshaft Front Cover 50 (37) Fuel Pump Drive Gear 60 (44)