2.1 ELECTRONIC UNIT PUMP EYE INJURY To avoid injury from flying parts when working with components under spring tension, wear adequate eye protection (face shield or safety goggles). 8. Carefully loosen the EUP mounting bolts about 6 mm (1/4 inch), but do not remove them yet. See Figure 2-5. 1. Mounting Bolt 2. Head of electronic unit pump Figure 2-5 Mounting Bolts 9. Using the engine barring tool (J–46392), rotate the crankshaft until the cam pushes the electronic unit pump upwards. All information subject to change without notice. 2-8 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION