Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 2.4.2 Installation of High Pressure Fuel Line and Transfer Tube Installation steps are as follows: NOTICE: New high pressure fuel injector lines are supplied ready for installation. Never use pliers or sharp-edged tools to bend injector lines. Doing so could damage them. High pressure fuel injector lines should fit without tension over the transfer tube and unit pump fittings. Discard the old high pressure fuel line and transfer tube. Do not re-use them! NOTICE: 1. Apply a light coat of clean engine oil to the transfer tube O-ring and install the transfer tube into the cylinder head. 2. Using a 24 mm socket, torque the thrust nut to 45 N·m (33 lb·ft). 3.

Align the new high pressure fuel injector line fittings to the transfer tube and unit pump. Ensure the fuel line is not installed backwards, and that the end of the high pressure fuel line is properly seated in the transfer tube and unit pump fitting. 4. Hand tighten the high pressure fuel injector line nut first at the unit pump, and then at the transfer tube. While hand tightening the nuts, gently move the high pressure fuel line back and forth to ensure the end of the line is properly seated in the transfer tube and unit pump fitting. See Figure 2-15 for the proper orientation of the fuel line.

If the high pressure fuel injector line has been installed incorrectly and torqued, remove the high pressure fuel All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 2-23