EPA07 MBE 4000 SERVICE MANUAL 5. Once the high pressure fuel injector line nuts are hand tight, draw a vertical line with a highly visible marker along the front edge of both of the nuts and up the fuel line. The line drawn along the edge of the nuts and the fuel line should be aligned. 1. Electronic Unit Pump End 2. Transfer Tube End Figure 2-16 Marking Of High Pressure Fuel Injector Line And Nuts 6. Using a 17 mm fuel line wrench (J-47483) or a 17 mm open end wrench, tighten the high pressure fuel line nut at the unit pump end by turning the nut through 120 degrees.
120 degrees can be measured by turning the nut so that the nut edge which had been marked has been turned through 1/3 of a full turn, or through two nut flats. Lack of space in some All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 2-25