2.4 HIGH PRESSURE FUEL LINE AND TRANSFER TUBE engine configurations may mean that the 120 degree turn will have to be completed in two turns of 60 degrees, or one nut flat each. Figure 2-17 Turning Fuel Line Nut 120 Degrees at Unit Pump End 7. Use a 24 mm fuel line wrench (J-45063 or J-47484), hold the transfer tube thrust nut. Using a 17 mm fuel line wrench (J-47483) or a 17 mm open end wrench, tighten the high pressure fuel injector line nut at the transfer tube end by turning the nut through 120 degrees. 120 degrees can be measured by turning the nut so that the nut edge which had been marked has been turned through 1/3 of a full turn, or through two nut flats.
Lack of All information subject to change without notice. 2-26 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION