2.5 FUEL INJECTOR HARNESS ADAPTOR FRAME 2.5 FUEL INJECTOR HARNESS ADAPTOR FRAME The following sections support the fuel injector harness adaptor frame. 2.5.1 Removal of Fuel Injector Harness Adaptor Frame Removal steps are as follows: 1. Caps Nuts 4. Injector Harness Adaptor Frame 2. Cylinder Head Cover 5. Cylinder Head 3. Studs (qty 2) Figure 2-20 Injector Harness Adaptor Frame 1. Remove the cylinder head cover(s). 2. Disconnect the electrical harness connector from the harness adaptor frame. 3. Disconnect the fuel injector electrical connector harness nuts from the fuel injector. 4. Using a stud removing tool, carefully remove the two cylinder head cover studs from the cylinder head. 5.
Remove the injector harness adaptor frame and adapter frame gasket from the cylinder head. Inspect the gasket, if damaged replace.See Figure 2-20. 2.5.2 Installation of Fuel Injector Harness Adaptor Frame Installation steps are as follows: All information subject to change without notice. 2-30 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION