EPA07 MBE 4000 SERVICE MANUAL 1. Install the gasket and adaptor frame on the cylinder head. See Figure 2-20. 2. Install the two cylinder head cover studs in the cylinder head. Torque the studs to 25 N·m (18 lb·ft). See Figure 2-20. 3. Connect the electrical harness connector nuts to the fuel injector. Torque the nuts to 2 N·m (1.5 lb·ft.). 4. Connect the electrical harness connector to the harness adaptor frame. 5. Install the gasket and the cylinder head cover(s). All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 2-31