Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

2.6 FUEL INJECTOR 2.6 FUEL INJECTOR The following sections support the repair of the fuel injector. 2.6.1 Removal of Fuel Injector Removal steps are as follows: 1. Remove the injector harness adaptor frame from the required cylinder head. Refer to section 2.5.2. NOTE: The MBE 4000 engine has individual heads for each cylinder. To remove the injector for one cylinder, do these procedures step by step. To remove all the fuel injectors, repeat each step in these instructions, as applicable, for all six cylinders. 2. Remove the air intake manifold.

FIRE To avoid injury from fire, keep all potential ignition sources away from diesel fuel, including open flames, sparks, and electrical resistance heating elements. Do not smoke when refueling. FIRE To avoid injury from fire caused by heated diesel-fuel vapors: Keep those people who are not directly involved in servicing away from the engine. Stop the engine immediately if a fuel leak is detected. Do not smoke or allow open flames when working on an operating engine. Wear adequate protective clothing (face shield, insulated gloves and apron, etc.). To prevent a buildup of potentially volatile vapors, keep the engine area well ventilated during operation.

All information subject to change without notice. 2-32 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION