Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

2.6 FUEL INJECTOR 6. Remove the heat isolator from the end of the fuel injector. Remove and discard the O-ring from the injector. See Figure 2-24. 1.Fuel Injector 4. Transfer-Tube 2. Heat Isolator 5. Thrust Bolt 3. O-ring Figure 2-24 Heat Isolator 7. If the injector heat isolator remains in the cylinder head during the removal of the fuel injector it can be removed by using the injector tip copper puller (J–46933). [a] Install the end of the puller (J–46933) into the tip in the cylinder head. Turn the shaft of the tool to expand into the tip. [b] Use the slide hammer on the puller tool and remove and discard the heat isolator. [c] Remove the heat isolator from the tool.

[d] Clean and remove any debris found in the protective sleeve. If the sleeve cannot be cleaned remove the protective sleeve 2.6.2 Installation of Fuel Injector Installation steps are as follows: All information subject to change without notice. 2-36 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION