Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

2.7 PROTECTIVE SLEEVE [a] Insert the 4-toothed socket (J–46186) into the protective sleeve. Make sure the teeth of the socket engage the four openings on the protective sleeve. See Figure 2-28. [b] Loosen the protective sleeve with a ratchet by turning counterclockwise until the threads of the sleeve are disengaged from the cylinder head. [c] Attach the rubber-ended socket to the puller from injector sleeve puller (J–46381). [d] Insert the rubber-ended socket into the protective sleeve. Expand the rubber-ended socket by turning the handle on the tool counterclockwise. [e] Pull while rotating the protective sleeve counterclockwise to remove it from the cylinder head. 4.

Remove the O-ring from the cylinder head. See Figure 2-29. 1. Fuel Injector 3. Protective Sleeve 2.Injector Heat Isolator 4. O-ring Figure 2-29 Protective Sleeve O-ring NOTE: Replace the O-ring whenever the protective sleeve is removed. 2.7.2 Installation of Protective Sleeve Installation steps are as follows: 1. Clean the sealing surfaces of the protective sleeve and the cylinder head. 2. Lubricate the new O-ring with a light coating of engine oil. Install the O-ring in the cylinder head. 3. Install the protective sleeve into the cylinder head. Using the 4-toothed socket (J-46186) and turning in a clockwise direction torque the protective sleeve to 45 N·m (33 lb·ft). 4.

Install the fuel injector. Refer to section 2.6.2. All information subject to change without notice. 2-42 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION