Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 2.7 PROTECTIVE SLEEVE The following sections support the repair of the protective sleeve. 2.7.1 Removal of Protective Sleeve Removal steps are as follows: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. Drain the engine coolant into a clean container. If the coolant is clean, save it for later use. 2. Remove the fuel injector. Refer to section 2.6.1. NOTE:

The injector sleeve puller kit (J–46381) comes with two sockets; a 4-toothed and a rubber-ended socket. 3. Using the injector sleeve puller (J–46381), remove the protective sleeve from the cylinder head. See Figure 2-28. 1. Protective Sleeve 2. O-ring Figure 2-28 Protective Sleeve All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 2-41