2.6 FUEL INJECTOR 6. Lubricate a new transfer-tube O-ring with a light coating of engine oil and install it on the transfer-tube. NOTE: Do not tighten the thrust bolt until after the tensioning arm has been fully tightened to the correct torque value. 7. Install the transfer-tube in the cylinder head and secure with thrust bolt. Torque the thrust bolt 45 N·m (33 lb·ft). 8. Install the high pressure fuel line and transfer tube. Refer to section 2.4.2. 9. Install the air intake manifold. 10. Install the injector harness adaptor frame and new gasket and connect harness the electrical connector. 11. Install the cylinder head cover(s), as removed. All information subject to change without notice.
2-40 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION