2.8 MOTOR CONTROL MODULE 2.8 MOTOR CONTROL MODULE The following sections support the repair of the motor control module. 2.8.1 Removal of Motor Control Module Removal steps are as follows: 1. Disconnect the batteries. 2. Open the hood. 1. Engine Harness Electrical Connector (120–pin) 6. Vehicle Harness Electrical Connector (21–pin) 2. MCM Fuel Outlet Line to Fuel Pump 7. Hand Pump Fuel Line 3. Fuel Pump 8.Isolators 4. Fuel Heat Exchanger 9. MCM Mounting Bolts 5. Motor Control Module 10. Engine Harness Figure 2-30 Motor Control Module 3. Remove the banjo bolts and washers from fuel in and outlet lines on the fuel cooler of the MCM. Discard the washers. 4.
Lift up the slide on the locking unit to release the 21–pin vehicle wiring harness connector and disconnect it from the MCM. See Figure 2-30. 5. Rotate the safety latch to release the 120–pin engine harness connector and disconnect it from the MCM. All information subject to change without notice. 2-44 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION