Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 6. Remove the mounting bolts and isolators securing the MCM to the engine. Then remove the unit. See Figure 2-30. NOTE: Do not disassemble the MCM. It cannot be serviced. 2.8.1.1 Inspection of Motor Control Module Inspection steps are as follows: 1. Inspect the MCM for damage and replace if necessary. 2. Inspect the isolator for damage and replace if necessary. 2.8.2 Installation of Motor Control Module Installation steps are as follows: NOTE: If installing a new MCM after installation, program to proper settings for that engine serial number (ESN) using the programming station. 1. Position the bolts and isolators in MCM. 2.

Install the MCM on the cylinder block. Tighten the mounting bolts to 15 N·m (11 lb·ft). 3. Install the banjo bolts and new washers and secure the fuel in and outlet lines to the fuel cooler on the MCM. 4. Connect the vehicle wiring harness (21–pin) connector to the MCM. Pull sideways on the locking unit to lock it in place. 5. Connect the engine wiring harness (120–pin) connector to the MCM. Rotate the safety latch sideways to lock it in place. 6. Connect the batteries. 7. If a new MCM was installed it must be program to proper settings for the engine serial number using the programing station. All information subject to change without notice.

DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 2-45