2.10 FUEL FILTER HOUSING 4. Remove the priming valve assembly or banjo bolt and washers from the delivery line on the filter housing. Mark both sides of the connection with a paint pen. Discard the washers. See Figure 2-32. 5. Disconnect the fuel return line from the filter housing. Mark both sides of the connection with a paint pen. Discard the washers. NOTE: In a suitable container, catch any fuel that runs out of the filter housing or fuel return line. 6. Remove the drain line from the filter housing. Mark both sides of each connection with a paint pen. Discard the washers. 7. Remove the two bolts attaching the filter housing to the mounting bracket. 8.
Remove the filter housing from the engine. 9. Clean the fuel filter cap. Discard the filter element. 2.10.2 Installation of Fuel Filter Housing Installation steps are as follows: 1. Install the fuel filter housing on the mounting bracket and secure with two M10 x 40 mm bolts. Tighten the mounting bolts to 60 N·m (44 lb·ft). See Figure 2-32. 2. Install the drain line as removed. Install new washers on the M8 banjo bolt. Tighten the banjo bolt to 40–50 N·m (30–37 lb·ft). 3. Install the fuel delivery line, as removed. Install a new washers on the priming valve or M16 banjo bolt. Tighten the banjo bolt to 50 N·m (37 lb·ft). If removed, install priming nipple valve and torque to 15 N·m (11 lb·ft). 4.
Install the fuel return line, as removed. Install new washers on the M16 banjo bolt. Tighten the banjo bolt to 40–50 N·m (30–37 lb·ft). 5. Install a new filter element. Refer to section 2.9.2. All information subject to change without notice. 2-52 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION