Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

2.13 FUEL PUMP NOTE: Catch any fuel that runs out of the fuel pump or the fuel lines. 3. Remove the socket-head bolts attaching the fuel pump to the cylinder block. Discard the gasket. 4. Slowly remove the fuel pump from the engine, taking care not to damage the splined shaft on the fuel pump. 5. Discharge the fuel pump gasket. 2.13.2 Installation of Fuel Pump Installation steps are as follows: NOTICE: When inserting the fuel pump into the opening in the cylinder block directly behind the front camshaft cover, be careful not to damage the splined shaft of the pump. 1. Install the fuel pump on the cylinder block. See Figure 2-37. 1. Splined Shaft 2.

Fuel Pump Figure 2-37 Fuel Pump Shaft [a] Install a new gasket on the connection to the cylinder block. [b] Work the splined shaft slowly and carefully into the opening in the cylinder block until it meshes with the camshaft drive gear. [c] Install and tighten the three socket-head bolts that attach the fuel pump to the cylinder block. Tighten the socket-head bolts to 25 N·m (18 lb·ft). All information subject to change without notice. 2-58 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION