Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

2.17 FUEL DOSER VALVE COOLANT LINES 1. Drain the coolant from the engine and save for reuse. 2. Remove the bolt securing the clamp on the FDV coolant inlet line to the cylinder block. 3. Remove the banjo bolts and washers for the FDV coolant inlet from the cylinder block and FDV and remove the line. Discard the washers. See Figure 2-44. 4. Remove the bolt securing the clamp on the FDV coolant outlet line to the cylinder block. 5. Remove the banjo bolts and washers for the FDV coolant outlet line from the cylinder head and FDV and remove the line. Discard the washers. See Figure 2-44. 2.17.2 Installation of Fuel Doser Valve Coolant Lines Installation steps are as follows: 1.

Install the banjo bolts and new washers and secure the FDV coolant outlet line to the cylinder head and FDV. Torque the banjo bolts to 16-20 N·m (12-15 lb·ft). See Figure 2-44. 2. Secure the FDV coolant inlet line with clamp and bolt to the cylinder block. Torque the bolt to 25-30 N·m (18–22 lb·ft). 3. Install the banjo bolts and new washers and secure the FDV coolant inlet line to the cylinder block and FDV. Torque the banjo bolts to 16-20 N·m (12-15 lb·ft). See Figure 2-44. 4. Secure the FDV coolant outlet line with clamp and bolt to the cylinder block. Torque the bolt to 25-30 N·m (18–22 lb·ft). All information subject to change without notice.

2-72 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION