Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 3.2 OIL PAN Perform the following procedures for removal and installation of the oil pan. 3.2.1 Removal of Oil Pan Removal steps are as follows: 1. Drain the engine oil. See Figure 3-2 for location of the drain plug. Discard the drain plug seal. Figure 3-2 Engine Oil Drain Plug PERSONAL INJURY To avoid injury when removing or installing a heavy engine component, ensure the component is properly supported and securely attached to an adequate lifting device to prevent the component from falling. 2. Using a floor jack, raise up the vehicle and place it on stands located behind the front suspension. 3. Loosen all front suspension shackle bolts. 4.

Remove the front spring bolts and shock absorber bolts. Using the floor jack, lower the axle to the ground. 5. Remove the oil fill-tube and oil dipstick. Refer to section 3.9.1. 6. Remove the oil pan from the cylinder block. 7. Remove and discard the oil pan gasket. Save the bolts. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 3-5