Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

3.2 OIL PAN 8. Thoroughly clean the pan. Remove all traces of gasket material from the pan and from the block. 3.2.2 Installation of Oil Pan Installation steps are as follows: 1. Position a new gasket on the oil pan. 2. Install the pan on the block and tighten each oil pan bolts to 35 N·m (26 lb·ft). See Figure 3-3 for the tightening pattern. When all the bolts have been tightened, go back and re-tighten the four corner bolts (positions #1 through #4). Figure 3-3 Oil Pan Bolt Tightening Pattern 3. Install the oil fill-tube and oil dipstick. Refer to section 3.9.2. 4. Fill the engine oil circuit. The correct oil fill capacity is listed in table.

See Table 3-4 in the Additional Information section. 5. Using the floor jack, raise the axle until it is in position to install the spring bolts and shock absorber bolts. Install the front suspension. 6. Tighten the shackle bolts and adjust the suspension. Refer to the appropriate vehicle service manual. 7. Remove the stands and lower the vehicle to the ground. All information subject to change without notice. 3-6 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION