Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

3.3 PISTON OIL SPRAY NOZZLE 3.3 PISTON OIL SPRAY NOZZLE The six piston oil spray nozzles are internally located in the cylinder block. The nozzles provide additional lubrication and cooling to the piston and rings. Perform the following procedures for the removal and installation of the piston oil spray nozzle(s). 3.3.1 Removal of Piston Oil Spray Nozzle(s) Removal steps are as follows: NOTE: These procedures refer to bolt-on piston oil spray nozzles only. 1. Remove the oil pan. Refer to section 3.2.1. 2. Remove the inspection cover on the flywheel housing and install the engine barring tool (J–46392). See figure 3-5. Rotate the crankshaft to gain access to the nozzles.

1.Flywheel Housing Inspection Cover Figure 3-5 Engine Barring Tool All information subject to change without notice. 3-8 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION