Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 3. Remove the hollow-core bolt that attaches each piston oil spray nozzle to the underside of the cylinder block. Remove the piston oil spray nozzle from the engine. See Figure 3-6. 1. Piston Oil Spray Nozzle 2. Hollow-Core Bolt Figure 3-6 Piston Oil Spray Nozzle(s) 4. Check the piston oil spray nozzle(s) for damage or contact by the piston.. Replace any nozzle that has been damaged. 3.3.2 Installation of Piston Oil Spray Nozzle(s) Installation steps are as follows: NOTICE: Ensure that the oil spray nozzle is properly aligned in the center of the lubrication hole in the bottom of the piston.

Incorrect alignment will result in inadequate lubrication and cooling of the piston and piston failure. 1. Install each piston oil spray nozzle in the block with the locator pin correctly installed. Tighten the hollow core bolt finger tight to ensure proper alignment with the lubrication All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 3-9