EPA07 MBE 4000 SERVICE MANUAL [a] Slowly bar the engine while observing the hole in the bottom of the piston and the alignment with the oil spray nozzle. Check that the alignment of the oil spray nozzle tip is in the center of the piston oil lubricating hole. The tip of the nozzle should be inside the piston oil hole and centered. Repeat the check for the remaining nozzles. See Figure 3-8. [b] If the oil spray nozzle does not align in the center of the piston oil lubricating hole or is not inside the oil hole in the piston, replace the nozzle. Do not bend the nozzles to align. 3. Remove the engine barring tool (J–46392) and install the inspection cover.
Torque bolts on cover to 25 N·m (18 lb ft). See figure3-9. 1. Flywheel Housing Inspection Cover Figure 3-9 Engine Barring Tool 4. Install the oil pan. Refer to section 3.2.2. 5. Fill the crankcase to the specified oil capacity listed in Table 3-4. Do not overfill the crankcase. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 3-11