3.5 OIL PUMP AND SUCTION PIPE 2. Seat the pump drive gear in the pump housing. Using an appropriate drift, press in the heated drive wheel until the pump drive gear projects slightly past the top of the drive wheel. See Figure 3-16. 1. Pump Drive Gear 2. Drive Wheel Figure 3-16 Positioning the Drive Wheel on the Pump Drive Gear 3. Using a feeler gauge, measure the projection of the pump drive gear. Adjust the position of the pump drive gear until the projection equals 0.5 mm (0.02 in.), as listed in Table 3-2. Table 3-2 Oil Pump Installation Specifications 4. Seat the idler gear in the pump housing. 5. Install the face plate on the pump housing. Tighten the mounting bolts 25 N·m (18 lb·ft).
All information subject to change without notice. 3-18 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description mm (in.) Projection of Pump Drive Gear 0.5 (0.02) Pump/Idler Gear End Play 0.050-0.128 (0.0020-0.0050) Backlash of Oil Pump Drive Gear and Crankshaft Gear 0.077-0.333 (0.0030-0.1311)