3.5 OIL PUMP AND SUCTION PIPE 2. Position the oil pump on the cylinder block. Make sure the teeth on the drive wheel of the oil pump mesh with the teeth of the crankshaft drive gear. Tighten the oil pump mounting bolt to 35 N·m (26 lb·ft). See Figure 3-14. 1. Valve Mounting Bolts 6. Sump Pipe Mounting Bolt 2. Pressure Relief Valve 7. Sump Pipe 3. Oil Pump 8. Bracket 4 .Oil Pump Mounting Bolt 9. Bracket Mounting Bolt 5. Gasket Figure 3-18 Oil Pump and Sump Pipe NOTE: It may be necessary to rock the pump counterclockwise so the teeth of the drive wheel can properly align with the crankshaft drive gear. 3. Check the backlash between the oil pump drive and the crankshaft gear.
The specification is 0.077-0.333 mm (0.003-0.131 in.) 4. Install the pressure relief valve on the oil pump. Tighten the valve mounting bolt 35 N·m (26 lb·ft). 5. Install the sump pipe to the oil pump. Tighten all mounting bolts to 25 N·m (18 lb·ft). [a] Install the sump pipe bracket on the cylinder block. [b] Install the sump pipe, with a new gasket, on the oil pump. 6. Install the oil pan with a new gasket. Refer to section 3.2.2. 7. Fill the engine oil circuit. The correct oil fill capacity is listed in Table 3-4. Do not overfill the crankcase. All information subject to change without notice. 3-20 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION