Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

4.2 COOLANT PUMP 4.2 COOLANT PUMP Perform the following procedures for removal and installation of the coolant pump. 4.2.1 Removal of Coolant Pump Removal steps are as follows: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. Drain the coolant from the engine. Refer to section 4.1.1. 2. For engines equipped with the Extreme Cold Climate (EC2) package, remove the coolant return line from the air intake manifold to the coolant pump. 3.

Remove the fan from the coolant pump. 4. Release the tension on the main drive belt and the fan belt and remove the belts. 5. Remove the plate covering the EGR valve. 6. Remove the two bolts securing the EGR valve to the thermostat housing. 7. Remove the front lifting bracket. 8. Remove the banjo fitting and washers securing the Fuel Doser Valve (FDV) coolant return line for the coolant pump. Discard the washers. 9. Remove the thermostats. Refer to section 4.4.1. All information subject to change without notice. 4-8 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION