Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 10. Remove the coolant pump pulley from the coolant pump housing. See Figure 4-2. 1. Coolant Pump Pulley Mounting Bolt 4. Coolant Pump Housing 2. Coolant Pump Pulley 5. Gasket 3. Hub 6. Coolant Pump Mounting Bolt Figure 4-2 Coolant Pump 11. Remove the coolant pump from the cylinder block. Discard the gasket. See Figure 4-2. NOTE: Catch any coolant that runs out of the inlet pipe or coolant pump in a suitable container. 12. On both the coolant pump and the cylinder block, clean the sealing surfaces (where the gasket was attached) of any adhering bits of gasket material. 13. Remove the thermostat housing, thermostats and seal rings from the coolant pump housing.

Refer to section 4.4.1. 14. Remove any other hose or fitting connections. 4.2.2 Disassembly of Coolant Pump Disassembly steps are as follows: 1. Remove the coolant pump from the engine. Refer to section 4.2.1. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 4-9