Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

4.2 COOLANT PUMP 4. Using an appropriate drift, press the drive shaft and bearing assembly out of the impeller and through the coolant pump housing. This frees the impeller from the housing. See Figure 4-5. 1. Sleeve Seal 4. Receptacle 2. Drift 5. Drive Shaft and Bearing Assembly 3. Impeller Figure 4-5 Drive Shaft 5. Remove the sleeve seal from the coolant pump housing. 4.2.2.1 Inspection of Coolant Pump Inspection steps are as follows: 1. Check all coolant pump components for signs of damage. Replace any damaged components. All information subject to change without notice. 4-12 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION