Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 2. Measure the following wear dimensions. Replace any component that is not within tolerance as listed in Table 4-3. Table 4-3 Coolant Pump Assembly Wear Dimensions 4.2.3 Assembly of Coolant Pump Assembly steps are as follows: 1. Press the drive shaft and bearing assembly into the coolant pump housing. See Figure 4-6. 1. Impeller Shaft and Bearing Assembly 2. Coolant Pump Housing Figure 4-6 Impeller Shaft [a] Place the coolant pump housing in a press. [b] Place the coolant pump pressure piece (Part of Toolset J–45388) over the outer bearing race. [c] Place the receptacle (Part of Toolset J–45388) under the coolant pump housing.

All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 4-13 Description Wear Dimensions, mm (in.) Drive Shaft Diameter (at the hub) 25.048-25.061 (0.9861-0.9867) Hub Inside Diameter 24.995-25.008 (0.9841-0.9846) Bearing Outside Diameter 54.981-54.994 (2.1646-2.1651) Bearing Housing Diameter 54.930-54.960 (2.1626-2.1638) Drive Shaft Diameter (at the impeller) 15.045-15.056 (0.5923-0.5928) Impeller Inside Diameter 15.000-15.018 (0.5906-0.5913) Impeller Outside Diameter 124-125 (4.88-4.92) Impeller - Maximum Out-Of-Round 0.15 (0.0059)