Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

4.2 COOLANT PUMP NOTICE: To prevent damage to the drive shaft and bearing assembly, press only on the outer bearing race. [d] Press the outer race of the bearing into the coolant pump housing. 2. Secure the bearing in place with the snap ring. PERSONAL INJURY To avoid injury from hot surfaces, wear protective gloves, or allow engine to cool before removing any component. 3. Press the hub onto the impeller shaft and bearing assembly. [a] Heat the hub to 80°C (175°F). NOTICE: To prevent damage to the bearing, make sure the drive shaft is supported evenly before pressing on the hub.

[b] Press the hub onto the impeller shaft, while holding the bearing and shaft assembly to prevent it from turning. Make sure the hub is flush with the end of the drive shaft. 4. Using the coolant pump bearing drift (J-35988–19), press the sleeve seal into the coolant pump housing. See Figure 4-7. 1. Impeller 3. Sleeve Seal 2. Drive Shaft Figure 4-7 Sleeve Seal All information subject to change without notice. 4-14 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION