Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 4.6 CYLINDER HEAD COOLANT VENT LINE Perform the following procedures for removal and installation of the cylinder head coolant vent line. 4.6.1 Removal of Cylinder Head Coolant Vent Line Remove as follows: 1. Drain the cooling system. 2. Remove air cleaner assembly. 3. Remove the radiator support bracket from the top of the EGR cooler bracket and radiator. 4. Disconnect the coolant vent line located on top of the EGR cooler by removing the banjo bolt and seal rings. Discard the seal rings. 5. Remove the bolt securing the air compressor suction supply bracket to the EGR cooler bracket. See Figure 4-14. Figure 4-14 Air Compressor Suction Supply Bracket 6.

Remove the two bolts securing the turbocharger inlet elbow to the EGR cooler bracket. Rotate the turbocharger inlet elbow away from the engine. NOTE: Do not remove the turbocharger air inlet elbow. 7. Remove the clamp halves securing the exhaust gas inlet pipe to the EGR cooler and to the center pipe of the exhaust manifold. Remove the exhaust gas inlet pipe. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 4-25