Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

4.5 ENGINE COOLANT TEMPERATURE SENSOR 4. Remove the electrical connector from the Engine Coolant Temperature Sensor. 5. Unscrew the Engine Coolant Temperature Sensor from the wall of the cylinder block. 4.5.2 Installation of Engine Coolant Temperature Sensor Installation steps are as follows: 1. Install the new sensor into the hole in the cylinder block, as removed. Torque the sensor to 30 Nm (22 lb-ft) 2. Connect the electrical connector to the Engine Coolant Temperature Sensor. Make sure the connection is secure. 3. Install the engine trim panel. Refer to section 1.1.2. 4. Fill the engine with the required amount of coolant, and check for leaks and proper operation.

All information subject to change without notice. 4-24 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION