Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 4.5 ENGINE COOLANT TEMPERATURE SENSOR The coolant temperature sensor is located on the left side of the cylinder block behind the engine harness, between unit pumps #2 and #3. 4.5.1 Removal of Engine Coolant Temperature Sensor Removal steps are as follows: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. Drain some coolant from the engine. NOTE: It is not necessary to drain all the coolant from the engine to do this procedure.

Enough has to be drained to prevent coolant from leaking out while the sensor is being changed. 2. Remove the engine trim panel from the left side of the engine. Refer to section 1.1.1. 3. Locate the Engine Coolant Temperature Sensor behind the engine harness, between unit pumps #2 and #3. See Figure 4-13. 1. Cylinder Block 3. Engine Coolant Temperature Sensor 2. High-Pressure Fuel Line 4. Engine Harness Figure 4-13 Engine Coolant Temperature Sensor Location All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 4-23